LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Engine Controls And Fuel - 1.4L (LUJ LUV) - DTC P0300 To DTC P2635 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2227-P2230: Barometric Pressure (BARO) Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition On.
  2. Verify DTC P0106, P0107, P0108, P0641, P0651, or P0697 is not set.
    • If none of the DTCs are set 
  3. Verify the scan tool MAP Sensor parameter is within the range specified in the Altitude Versus Barometric Pressure table.
    • If not within the specified range 

      Refer to DTC P0106 .

    • If within the specified range 
  4. Verify the scan tool BARO pressure parameter is within the range specified in the Altitude Versus Barometric Pressure table.
    • If the BARO is not within the specified range 

      Refer to Circuit/System Testing.

    • If the BARO is within the specified range 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed in the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals