Conditions for Running the DTC
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
P182E
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0722, or P0723 is not set.
- Engine speed is 400-7,500 RPM for 5 s.
- Ignition voltage is 9-32 V.
- Engine torque signal is valid.
- DTC runs continuously when the above conditions are met.
P1915
- DTC P0722, P0723, or P1915 is not set.
- Transmission output shaft speed is 90 RPM or less.
- Ignition voltage is 6-32 V.
- DTC runs when conditions above are met during engine start sequence.