LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Bolted Exterior Body Panels And Closures) >> Diagnostic Information and Procedures >> Hood Ajar Indicator/Message Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the B55 Hood Ajar Switch.
  2. Test for 2738-3350 Ω between the signal terminal A and the signal terminal B with the hood latch in the closed position.
    • If not between 2738-3350 Ω 

      Replace the B55 Hood Ajar Switch.

    • If between 2738-3350 Ω 
  3. Test for 658-806 Ω between the signal terminal A and the ground terminal C with the hood latch in the closed position.
    • If not between 658-806 Ω 

      Replace the B55 Hood Ajar Switch.

    • If between 658-806 Ω 
  4. Test for 2080-2545 Ω between the signal terminal B and the ground terminal C with the hood latch in the closed position.
    • If not between 2080-2545 Ω 

      Replace the B55 Hood Ajar Switch.

    • If between 2080-2545 Ω 
  5. Test for 2738-3350 Ω between the signal terminal A and the signal terminal B with the hood latch in the open position.
    • If not between 2738-3350 Ω 

      Replace the B55 Hood Ajar Switch.

    • If between 2738-3350 Ω 
  6. Test for 2080-2545 Ω between the signal terminal A and the ground terminal C with the hood latch in the open position.
    • If not between 2080-2545 Ω 

      Replace the B55 Hood Ajar Switch.

    • If between 2080-2545 Ω 
  7. Test for 658-806 Ω between the signal terminal B and the ground terminal C with the hood latch in the open position.
    • If not between 658-806 Ω 

      Replace the B55 Hood Ajar Switch.

    • If between 658-806 Ω 
  8. All OK.