Component Testing

Driver Door Lock Switch

1. Ignition OFF, disconnect the harness connector at the S13D Door Lock Switch - Driver.
2. Test for infinite resistance between the signal terminal 2 and the ground terminal 3 with the switch in the center position.
   • If less than infinite resistance 

     Replace the S13D Door Lock Switch - Driver.

   • If infinite resistance 
3. Test for infinite resistance between the signal terminal 4 and the ground terminal 3 with the switch in the center position.
   • If less than infinite resistance 

     Replace the S13D Door Lock Switch - Driver

   • If infinite resistance 
4. Test for less than 2 Ω between the signal terminal 4 and the ground terminal 3 with the switch in the Lock position.
   • If 2 Ω or greater 

     Replace the S13D Door Lock Switch - Driver.

   • If less than 2 Ω 
5. Test for less than 2 Ω between the signal terminal 2 and the ground terminal 3 with the switch in the Unlock position.
   • If 2 Ω or greater 

     Replace the S13D Door Lock Switch - Driver.

   • If less than 2 Ω 
6. All OK

Passenger Door Lock Switch

1. Ignition OFF, disconnect the harness connector at the S13P Door Lock Switch - Passenger.
2. Test for infinite resistance between the signal terminal 2 and the ground terminal 3 with the switch in the center position.
   • If less than infinite resistance 

     Replace the S13P Door Lock Switch - Passenger.

   • If infinite resistance 
3. Test for infinite resistance between the signal terminal 4 and the ground terminal 3 with the switch in the center position.
   • If less than infinite resistance 

     Replace the S13P Door Lock Switch - Passenger

   • If infinite resistance 
4. Test for less than 2 Ω between the signal terminal 4 and the ground terminal 3 with the switch in the Lock position.
   • If 2 Ω or greater 

     Replace the S13P Door Lock Switch - Passenger.

   • If less than 2 Ω 
5. Test for less than 2 Ω between the signal terminal 2 and the ground terminal 3 with the switch in the Unlock position.
   • If 2 Ω or greater 

     Replace the S13P Door Lock Switch - Passenger.

   • If less than 2 Ω 
6. All OK

Door Latch Assembly

1. Ignition OFF, disconnect the harness connector at the appropriate A23 Door Latch Assembly.
2. Install a 25 A fused jumper wire between one of the control terminals and 12 V. Momentarily install a jumper wire between the other control terminal and ground. Reverse the jumper wires at least two times, the A23 Door Latch Assembly should perform the LOCK and UNLOCK function.
   • If the actuator does not perform the LOCK and UNLOCK function 

     Replace the A23 Door Latch Assembly.

   • If the actuator performs the LOCK and UNLOCK function 
3. All OK