LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Power Door Lock System And Release Systems) >> Diagnostic Information and Procedures >> Power Door Locks Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the scan tool Driver Door Lock Switch parameter changes from Inactive to Lock and Unlock when pushing the appropriate switch on the S13D Door Lock Switch-Driver.
    • If the parameter does not change 

      Refer to Circuit/System Testing - Driver Door Lock Switch Malfunction.

    • If the parameter changes 
  3. Verify the scan tool Passenger Door Lock Switch parameter changes from Inactive to Lock and Unlock when pushing the appropriate switch on the S13P Door Lock Switch - Passenger.
    • If the parameter does not change 

      Refer to Circuit/System Testing - Passenger Door Lock Switch Malfunction.

    • If the parameter changes 
  4. Verify all vehicle doors LOCK and UNLOCK when commanding the All Doors Lock/Unlock with a scan tool.
    • If only the driver door does not LOCK and UNLOCK 

      Refer to Circuit/System Testing - Driver Door Lock Malfunction.

    • If one or more passenger doors do not LOCK and UNLOCK 

      Refer to Circuit/System Testing - Passenger Door Lock Malfunction.

    • If all doors do not LOCK and UNLOCK 

      Refer to Circuit/System Testing - All Door Lock Inoperative.

    • If all doors LOCK and UNLOCK 
  5. All OK.
scientia non olet · About LEMON Manuals