Component Testing
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Fuel Door Latch
- Ignition OFF, disconnect the harness connector at the M97 Fuel Door Lock Actuator.
- Install a 25 A fused jumper wire between one of the control terminals and 12 V. Momentarily install a jumper wire between the other control terminal and ground. Reverse the jumper wires at least two times, the M97 Fuel Door Lock Actuator should perform the LOCK and UNLOCK function.
- If the actuator does not perform the LOCK and UNLOCK function
Replace the M97 Fuel Door Lock Actuator.
- If the actuator performs the LOCK and UNLOCK function
- If the actuator does not perform the LOCK and UNLOCK function
- All OK