Disarming an Armed System/Silencing an Alarm

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

If system arming has been requested by the keyless entry transmitter, it must be disarmed.

NOTE:

Disconnecting the battery or removing fuses does not disable the arm or alarm modes, since the BCM stores the content theft deterrent mode status in memory.

To disarm the content theft deterrent system in standby mode, perform one of the following:
- Press the UNLOCK button on the keyless entry transmitter.
- Insert a valid key into the ignition and switch to the ON position.
To disarm the content theft deterrent system in the armed mode (non-event) or when activated (during an alarm event):
- Press the UNLOCK button on the keyless entry transmitter.
- Insert a valid key into the ignition and switch to the ON position