LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt System Operational and Functional Checks >> Emergency Locking Retractors

Emergency Locking Retractors

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Perform this test in an area clear of other vehicles or obstructions. Do not conduct this test on the open road. A large, empty parking lot is suitable. Failure to observe this precaution may result in damage to the vehicle and possible personal injury.

  1. Fasten the seat belts, an assistant is needed when the retractor under test is not part of the driver seat belt.
  2. Accelerate the vehicle slowly to 16 km/h (10 mph) and apply the brakes firmly.
  3. Verify that the seat belt locks when braking firmly.
    4. NOTE:

    When performing this check, note the position that the retractors are mounted. Some retractors are not mounted at a zero degree inclination.

  4. If the belt does not lock, proceed with the following steps:
    1. Remove the seat belt retractor assembly.
    2. Tilt the seat belt retractor slowly.
      3. Fig 1: Checking Seat Belt Retractor Inclination
      GM157277Courtesy of GENERAL MOTORS COMPANY
    3. Ensure that the seat belt webbing can be pulled from the retractor at an inclination of 15 degrees forward or less, from the retractors mounted position.
    4. Ensure the retractor cannot be pulled from the retractor at an inclination of 45 degrees forward or more.
    5. If a seat belt retractor does not operate as described, replace the retractor assembly.
scientia non olet · About LEMON Manuals