LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Malfunction - Passenger >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF. Disconnect the harness connector at the B153P Seat Belt Buckle-Passenger. Buckle the B153P Seat Belt Buckle-Passenger.
  2. Test for infinite resistance between the signal circuit terminal 1 and the low reference terminal 2 at the B153P Seat Belt Buckle-Passenger.
    • If less than infinite resistance 

      Replace the B153P Seat Belt Buckle-Passenger.

    • If infinite resistance 
  3. Unbuckle the B153P Seat Belt Buckle-Passenger.
  4. Test for less than 1 Ω between the signal circuit terminal 1 and the low reference terminal 2 at the B153P Seat Belt Buckle-Passenger.
    • If 1 Ω or greater 

      Replace the B153P Seat Belt Buckle-Passenger.

    • If less than 1 Ω 
  5. All OK.
scientia non olet · About LEMON Manuals