LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Malfunction - Driver >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the B153D Seat Belt Buckle-Driver, buckle the driver seat belt.
  2. Test for infinite resistance between the signal circuit terminal 1 and the low reference terminal 2.
    • If not infinite resistance 

      Replace the B153D Seat Belt Buckle-Driver.

    • If infinite resistance 
  3. Unbuckle the driver seat belt.
  4. Test for less than 1 Ω between the signal circuit terminal 1 and the low reference terminal 2.
    • If 1 Ω or greater 

      Replace the B153D Seat Belt Buckle-Driver.

    • If less than 1 Ω 
  5. All OK.
scientia non olet · About LEMON Manuals