LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel bearing and hub assembly in the steering knuckle. Refer to Front Wheel Bearing and Hub Replacement .
    2. Fig 1: Steering Knuckle Assembly
    GM2504711Courtesy of GENERAL MOTORS COMPANY
  2. Position the steering knuckle (1) on the vehicle.
  3. Connect the strut assembly to the steering knuckle. Refer to Strut Assembly Removal and Installation .
  4. Connect the lower control arm to the steering knuckle. Refer to Lower Control Arm Replacement .
  5. Install the front brake shield. Refer to Front Brake Shield Replacement .
  6. Connect the front wheel drive shaft to the steering knuckle. Refer to Front Wheel Drive Shaft Replacement - Left Side , or Front Wheel Drive Shaft Replacement - Right Side .
  7. If equipped, install the front wheel speed sensor in the steering knuckle. Refer to Front Wheel Speed Sensor Replacement .
  8. Connect the steering linkage outer tie rod to the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. If the vehicle had a camber adjustment repair, check the front wheel alignment. Refer to Wheel Alignment Specifications .
scientia non olet · About LEMON Manuals