LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Rear Suspension System) >> Repair Instructions >> Rear Wheel Bearing and Hub Replacement (With Disc Brakes) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Adapter, Press Extension And Bearing
    GM2791957Courtesy of GENERAL MOTORS COMPANY
  1. Using the Ch-50559-4  adaptor (2) the appropriate extension and press (1), install the NEW bearing (3) into the rear knuckle until it is correctly seated.
    2. Fig 2: Special Tool
    GM2852753Courtesy of GENERAL MOTORS COMPANY
  2. Position the Ch-50559-4  adaptor (1) to the inside of the bearing and position the Ch-50559-2  adaptor (2) and the appropriate extension on the wheel hub.
    3. Fig 3: Retaining Ring
    GM2781349Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure that the retaining ring is seated in the original position.

  3. Using the appropriate tool, install the retaining ring (1).
    4. Fig 4: Wheel Hub Assembly
    GM2770744Courtesy of GENERAL MOTORS COMPANY
  4. Position the wheel bearing/hub assembly (1) in the rear axle.
    5. Fig 5: Wheel Hub Bolts
    GM2769771Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  5. Install the 4 wheel hub bolts (1) and tighten to 58 N.m (43 lb ft)
  6. Install the rear wheel speed sensor. Rear Wheel Speed Sensor Replacement
  7. Install the rear brake shield. Rear Brake Shield Replacement (All Wheel Drive)Rear Brake Shield Replacement (Front Wheel Drive)
  8. Install the NEW wheel drive shaft nut. Rear Wheel Drive Shaft Replacement
  9. Install the tire and wheel assembly. Tire and Wheel Removal and Installation
  10. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals