LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Heating, Ventilation, And Air Conditioning) >> Diagnostic Information and Procedures >> Defrosting Insufficient

Defrosting Insufficient

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Yes No
DEFINITION: Time required to defrost the windshield is longer than normal.
1 Were you sent here from Symptoms or another diagnostic table? Go to Step 2  Go to Symptoms - HVAC Systems - Automatic , or Symptoms - HVAC Systems - Manual
2
  1. Start the engine.
  2. Select the DEFROST mode.
  3. Select the maximum blower speed.
Does sufficient air flow from the defroster outlets?
Go to Step 3  Go to Step 9 
3 Measure the engine operating temperature.
Does engine reach a normal operating temperature?
Go to Step 4  Go to Step 7 
4
  1. Select the minimum blower speed.
  2. Select the maximum temperature setting.
  3. Feel the temperature of the inlet and outlet hoses near the heater core.
Does the inlet hose feel warmer than the outlet hose?
Go to Step 10  Go to Step 5 
5 Test the operation of the A/C compressor clutch.
Does the A/C compressor clutch engage?
Go to Step 8  Go to Step 6 
6 Repair the A/C compressor clutch concern. Refer to DTC P0645, P0646, or P0647 .
Is the repair complete?
Go to Step 12  -
7 Repair the low engine temperature concern. Refer to Engine Fails To Reach Normal Operating Temperature .
Is the repair complete?
Go to Step 12  -
8 Inspect for correct operation of the air inlet door.
Is the air inlet door operating correctly?
Go to Step 12  Go to Step 11 
9 Repair the air delivery concern. Refer to Diagnostic Starting Point - Vehicle .
Is the repair complete?
Go to Step 12  -
10 Repair the heating concern. Refer to Heating Performance Diagnostic .
Is the repair complete?
Go to Step 12  -
11 Repair the air inlet door concern. Refer to Diagnostic Starting Point - Vehicle .
Is the repair complete?
Go to Step 12  -
12 Operate the system in order to verify the repair.
Did you find and correct the problem?
System OK Go to Step 2