LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Transfer Case - AAM) >> Repair Instructions - On Vehicle >> Transfer Case Adapter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Bracket And Through Bolt
    GM2759935Courtesy of GENERAL MOTORS COMPANY
  1. Install the transfer case adapter (2) to the transmission.
    2. Fig 2: Transmission Adapter Bolts
    GM2759903Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. For manual transmission, install the NEW transfer case adapter to transmission fasteners (1) and tighten to 100 N.m (74 lb ft) plus 30-40 degrees.
    3. Fig 3: Transmission Bracket Fasteners
    GM2842321Courtesy of GENERAL MOTORS COMPANY
  3. For automatic transmission, install the NEW transfer case adapter to transmission fasteners (1) and tighten to 100 N.m (74 lb ft) plus 30-40 degrees.
  4. Install the NEW transfer case adapter to transmission fastener (2) and tighten to 60 N.m (44 lb ft) plus 60-75 degrees.
    5. Fig 4: Transmission Bracket And Through Bolt
    GM2759935Courtesy of GENERAL MOTORS COMPANY
  5. Install the NEW rear transmission mount through bolt (1) and tighten to 80 N.m (59 lb ft) plus 45-60 degrees.
    6. Fig 5: Transfer Case-To-Transfer Case Bracket Seal
    GM2759854Courtesy of GENERAL MOTORS COMPANY
  6. Lightly lubricate the adapter seal (1) with transmission oil prior to installation.
  7. Install the NEW transfer case adapter seal to the transfer case adapter. Refer to Transfer Case Adapter Assemble .
  8. Install the transfer case. Refer to Transfer Case Replacement .
scientia non olet · About LEMON Manuals