Transfer Case Fill Plug, Oil Drain Plug, and Vent Hose Connector Installation

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Fill Plug, Oil Drain Plug And Vent Hose Connector

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Transfer Case Oil Drain Plug Seal NOTE: The plug and seal are only available as an assembly. Install a NEW plug with seal during assembly.
2	Transfer Case Oil Drain Plug NOTE: The plug and seal are only available as an assembly. Install a NEW plug with seal during assembly. Tighten 40 N.m (30 lb ft)
3	Transfer Case Oil Fill Plug Seal NOTE: The plug and seal are only available as an assembly. Install a NEW plug with seal during assembly.
4	Transfer Case Oil Fill Plug Procedure Tighten the oil fill plug only after the assembly has been filled with fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers . NOTE: The plug and seal are only available as an assembly. Install a NEW plug with seal during assembly. Tighten 40 N.m (30 lb ft)
5	Transfer Case Vent Hose Connector Procedure Apply sealant to the threads of the connector. Refer to Adhesives, Fluids, Lubricants, and Sealers . Tighten 25 N.m (18 lb ft)