Removal Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Disconnect the heated oxygen sensor - position 2 from the exhaust front pipe.
- Remove the 2 fasteners (4) securing the warm up 3 way catalytic converter (3) to the exhaust front pipe (5).
- Discard the exhaust front pipe gasket (2).
- Remove the 3 fasteners (2) securing the exhaust front pipe (3) to the catalytic converter.
- Discard the exhaust front pipe gasket (1).
- Remove the exhaust front pipe (3).
- If you are replacing the exhaust front pipe, transfer the heated oxygen sensor.
WARNING:
Refer to Exhaust Service Warning .
WARNING:
Refer to Protective Goggles and Glove Warning .