Diagnostic Aids
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- The scan tool cooling fan output control operates as follows:
- Cooling Fan Relay 1 operates the fan at a low speed
- Cooling Fan Relay 2 and 3 operates the fan at a medium speed
- Cooling Fan Relay 1, 2 and 3 operates the fan at a high speed
- Certain resistance conditions with intake air temperature (IAT) or engine coolant temperature (ECT) sensors may cause unwarranted cooling fan activation. If the ECM is commanding the cooling fans ON for no apparent reason and without any component or system DTCs set, the IAT or ECT sensor may be skewed. If this condition is suspected, refer to the Temperature Versus Resistance tables in Specifications of the appropriate engine controls subsection.
- If the cooling fan operates at high speed when the ECM is requesting medium speed operation, test or replace the KR20E Cooling Fan Speed Control Relay.