LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Frame And Underbody) >> Repair Instructions >> Drivetrain and Front Suspension Frame Replacement (Short Cradle) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the drivetrain and front suspension frame transmission protector from the front frame, if equipped. Refer to Drivetrain and Front Suspension Frame Transmission Protector Replacement .
  4. Remove the front compartment front center insulator, if equipped. Refer to Front Compartment Front Center Insulator Replacement .
  5. Disconnect the lower ball joints from the steering knuckles. Refer to Lower Control Arm Replacement .
    6. Fig 1: Stabilizer Shaft Insulator Bracket And Bolts
    GM2506890Courtesy of GENERAL MOTORS COMPANY
  6. Remove the four fasteners (1) retaining the stabilizer shaft to the drivetrain and front suspension.
    7. Fig 2: Steering Rack Retaining Bolts & Exhaust Isolators
    GM2531740Courtesy of GENERAL MOTORS COMPANY
  7. Remove the steering rack retaining fasteners (1) and discard.
  8. Using mechanics wire, secure the power steering gear and stabilizer shaft to the vehicle.
  9. Disconnect the hydraulic power steering hoses from the front frame.
  10. Disconnect the exhaust isolators (2) from the front suspension frame.
  11. Disconnect the power brake booster pump hose and connector, if equipped.
    12. Fig 3: Transmission Mount Bracket To Rear Mount Through Bolt
    GM2888245Courtesy of GENERAL MOTORS COMPANY
  12. Remove the rear transmission mount bracket to rear mount through fasteners (1).
  13. Using a suitable support table or equivalent, support the front suspension frame.
    14. Fig 4: Upper Frame Suspension Retaining Bolts
    GM2888252Courtesy of GENERAL MOTORS COMPANY
  14. Remove the two upper frame suspension retaining fasteners (1).
    15. Fig 5: Frame Rear Fasteners
    GM2888253Courtesy of GENERAL MOTORS COMPANY
  15. Remove the two frame rear fasteners (1).
  16. Remove the frame (2) from the vehicle.
  17. Remove the following components, if replacing the frame:
scientia non olet · About LEMON Manuals