LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement >> Intake Valve Stem Oil Seal Removal Cylinder 2

Intake Valve Stem Oil Seal Removal Cylinder 2

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the air pressure from cylinder 4.
  2. Raise the vehicle.
  3. Remove the EN-952  fixing pin from the crankshaft.
    4. Fig 1: Crankshaft Balancer Markings
    GM2373175Courtesy of GENERAL MOTORS COMPANY
  4. Rotate the crankshaft balancer in engine rotation direction until the 180° opposite marking (2) aligns with the marking (1) on the engine front cover.
  5. Lower the vehicle.
    6. NOTE:

    Wheels must contact the ground.

  6. Block the engine by shifting the 5. gear (MT) or park position (AT) and applying the park brake.
  7. Transfer the EN-6086-15  pneumatic adapter from cylinder 4 to the spark plug bore of cylinder 2.
  8. Apply air pressure to cylinder 2.
  9. Transfer the EN-6086-7  lever to the intake side of cylinder 2.
  10. Replace the EN-6086-200-1  mounting piece with the EN-6086-11  demounting piece.
  11. Remove the intake valve keys, intake valve spring retainers, intake valve springs and the intake valve stem oil seals of cylinder 2 as described above.
scientia non olet · About LEMON Manuals