LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement >> Intake Valve Stem Oil Seal Installation Cylinder 1

Intake Valve Stem Oil Seal Installation Cylinder 1

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Intake Valve Stem Oil Seal Installation Tool
    GM2373172Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Lubricate the NEW intake valve stem oil seals with clean engine oil.

  1. Install the NEW intake valve stem oil seals of cylinder 1, using the EN-958  installer (1).
    2. Fig 2: Valve Key Installation Mounting Piece Components
    GM2189662Courtesy of GENERAL MOTORS COMPANY
  2. Prepare the EN-6086-200-1  mounting piece for the valve key installation. The mounting piece must be assembled in the following order:
    1. Support (6)
    2. Bushing (5)
    3. Spring (4)
    4. EN-6086-200-10  plunger (3)
    5. Screw Connection (2)
    6. Lever Adapter (1)
    3. Fig 3: Valve Keys And Mounting Piece
    GM2189663Courtesy of GENERAL MOTORS COMPANY
  3. Install the valve keys (1) to the mounting piece (2) and fix them with the bushing.
    4. Fig 4: Assembled Mounting Piece
    GM2373173Courtesy of GENERAL MOTORS COMPANY
  4. Install the intake valve springs, the intake valve spring retainers and the intake valve keys, using the following procedure:
    1. Replace the EN-6086-11  demounting piece with the assembled EN-6086-200-1  mounting piece (1).
    2. Install the intake valve springs and the intake valve spring retainers to the cylinder head.
      3. CAUTION:

      The demounting piece part of EN-6086 Basic Kit, Spring and Wedge Replacer must be applied parallel to the valve retainers in order to prevent damage to the tools or the valve train components. If demounting piece is not applied parallel it could cause damage to the valve stem keys or the valve retainers.

      NOTE:

      The cone side of the valve keys must point to the valve stem.

    3. Push down the mounting piece (1) using the lever (2) until the valve keys are hearable engaged.
      4. Fig 5: Intake Valve Keys
      GM2373174Courtesy of GENERAL MOTORS COMPANY
    4. Inspect the intake valve keys (1) for proper seat.
scientia non olet · About LEMON Manuals