LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Turbocharger Oil Feed Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the sealing surfaces.
    2. Fig 1: Turbocharger Oil Feed Pipe Components
    GM2192280Courtesy of GENERAL MOTORS COMPANY
  2. Install the turbocharger oil feed pipe (2) along with a NEW rubber seal ring.
  3. Install the turbocharger oil feed pipe hollow screw (4) and 2 NEW seal rings (1) and (3).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the turbocharger oil feed pipe bolt (5) and tighten to 8 N.m (71 lb in).
  5. Tighten the turbocharger oil feed pipe hollow screw to 20 N.m (15 lb ft).
  6. Install the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (LUV) .
  7. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals