LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Intake Camshaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft intake and exhaust sprocket. Refer to Camshaft Intake and Exhaust Sprocket Replacement .
    2. Fig 1: Intake Camshaft Bearing Cap Bolts Removal Sequence
    GM2190728Courtesy of GENERAL MOTORS COMPANY
  2. Remove the camshaft bearing cap bolts in sequence shown. Ensure to remove the bolts one turn at a time until there is no spring tension pushing on the camshaft.
    3. Fig 2: Camshaft Bearing Caps And Bolts
    GM2403116Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Mark the camshafts bearing caps and the camshaft upon removal to ensure installation is in the correct position.

  3. Remove the camshaft bearing cap bolts (1).
  4. Remove the camshaft bearing caps (2).
  5. Remove the intake camshaft (3).
scientia non olet · About LEMON Manuals