LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Exhaust Camshaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft intake and exhaust sprocket. Refer to Camshaft Intake and Exhaust Sprocket Replacement .
    2. Fig 1: Camshaft Position Exciter Wheels And Camshaft Sprocket Bolts
    GM2191382Courtesy of GENERAL MOTORS COMPANY
  2. Remove and DISCARD the camshaft sprocket bolts (2) and the camshaft position exciter wheels (1).
  3. Allow the both camshaft sprockets with the timing chain to rest on the engine front cover.
    4. Fig 2: Exhaust Camshaft Bearing Cap Bolts Removal Sequence
    GM2190732Courtesy of GENERAL MOTORS COMPANY
  4. Remove the camshaft bearing cap bolts in sequence shown. Ensure to remove the bolts one turn at a time until there is no spring tension pushing on the camshaft.
    5. Fig 3: Camshaft Bearing Caps And Bolts
    GM2403118Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Mark the camshafts upon removal to ensure installation is in the correct position.

  5. Remove the camshaft bearing cap bolts (1).
  6. Remove the camshaft bearing caps (2).
  7. Remove the exhaust camshaft (3).
scientia non olet · About LEMON Manuals