LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Drive Belt Tensioner Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive belt. Refer to Drive Belt Replacement .
    2. Fig 1: Holding Wrench And Drive Belt Tensioner
    GM2191345Courtesy of GENERAL MOTORS COMPANY
  2. Install the EN-48488  holding wrench (2) to the drive belt tensioner (1).
    3. Fig 2: Locking Pin
    GM2191140Courtesy of GENERAL MOTORS COMPANY
  3. Move the drive belt tensioner clockwise until the drive belt tensioner can be fixed with EN-955  locking pin (1).
  4. Remove the EN-48488  holding wrench.
  5. Remove the drive belt.
  6. Repeat steps 4 and 5 in order to remove the EN-955  locking pin from the drive belt tensioner.
    7. Fig 3: Drive Belt Tensioner & Bolts
    GM2508840Courtesy of GENERAL MOTORS COMPANY
  7. Remove the lower drive belt tensioner bolt (1).
  8. Remove the upper drive belt tensioner bolt (2).
  9. Remove the drive belt tensioner (3).
scientia non olet · About LEMON Manuals