LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - On Vehicle >> Crankshaft Front Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Front Oil Seal And Installer
    GM2191466Courtesy of GENERAL MOTORS COMPANY
  1. Install NEW crankshaft front oil seal (1) to EN-960  installer (2).
    2. Fig 2: Crankshaft Front Oil Seal Installer And Engine Front Cover
    GM2191465Courtesy of GENERAL MOTORS COMPANY
  2. Install crankshaft front oil seal by means of EN-960  installer (1) to engine front cover (2).
    3. Fig 3: Engine Front Cover And Crankshaft Front Oil Seal
    GM2191467Courtesy of GENERAL MOTORS COMPANY
  3. Ensure that crankshaft front oil seal (2) is flush with engine front cover (1).
  4. Install crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  5. Remove the drain pan.
  6. Check and correct engine oil level.
scientia non olet · About LEMON Manuals