Warm Up Three-Way Catalytic Converter Installation
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install the warm up three way catalytic converter (5) to the brackets and the turbocharger. Use a NEW warm up three way catalytic converter seal (2).
- Install a NEW warm up three way catalytic converter V-clamp (1).
- Install the 2 catalytic converter to catalytic converter bracket nuts (4) and (6) and hand tighten.
- Hand tighten the catalytic converter V-clamp.
- Connect the heated oxygen sensor wiring harness (3) to retainer clip.
- The catalytic converter V-clamp (1) should be installed in the shown position.
- Tighten the catalytic converter to catalytic converter bracket nuts to 22 N.m (16 lb ft).
- Tighten the catalytic converter V-clamp to 13 N.m (115 lb in).
NOTE:
Never re-use the V-clamp.
CAUTION:
Refer to Fastener Caution .