LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - Off Vehicle >> Exhaust Camshaft Installation

Exhaust Camshaft Installation

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exhaust Camshaft, Camshaft Bearing Caps And Bolts
    GM2190733Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Mind the markings on the camshaft bearing caps. Camshaft bearing caps should be installed in their original position.

  1. Lubricate camshaft and camshaft bearing caps with engine oil.
  2. Install the exhaust camshaft (3).
  3. Install the 5 camshaft bearing caps (2).
  4. Install the 10 camshaft bearing cap bolts (1) and handtighten.
    5. Fig 2: Exhaust Camshaft Bearing Cap Bolts Tightening Sequence
    GM2190734Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    NOTE:

    Tighten the camshaft bearing cap bolts one turn at a time in order to avoid shape distortion of the camshaft.

  5. Tighten the camshaft bearing cap bolts one turn at a time and in a spiral sequence as shown to 8 N.m (71 lb in).
scientia non olet · About LEMON Manuals