LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - Off Vehicle >> Engine Oil Cooler Assemble

Engine Oil Cooler Assemble

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Oil Pressure Indicator Switch, Oil Filter Cap And Oil Filter Element
    GM2191944Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the engine oil filter cap (1) along with a NEW seal ring (2) and a NEW oil filter element (3) and tighten to 25 N.m (18 lb ft).
  2. Install the engine oil pressure indicator switch (5) and NEW seal ring (4) and tighten to 20 N.m (15 lb ft).
    3. Fig 2: Locating Engine Oil Cooler Components
    GM2191943Courtesy of GENERAL MOTORS COMPANY
  3. Install the oil cooler coolant outlet hose (5)
  4. Install the oil cooler coolant outlet hose clamp (4).
  5. Install the oil cooler coolant inlet pipe (3) and a NEW seal ring (6).
  6. Install the oil cooler coolant inlet pipe bolt (7) and tighten to 10 N.m (89 lb in).
  7. Install the oil cooler coolant inlet hose (1).
  8. Install oil cooler coolant inlet hose clamp (2).
scientia non olet · About LEMON Manuals