LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - Off Vehicle >> Engine Front Cover and Oil Pump Disassemble >> Oil Pump Removal

Oil Pump Removal

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Oil Pump Cover And Bolts
    GM2191037Courtesy of GENERAL MOTORS COMPANY
  1. Remove the 8 oil pump cover bolts (1).
  2. Remove the oil pump cover (2).
    3. Fig 2: Oil Pump Slide Spring Windings And Engine Front Cover Edge
    GM2191038Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Before removing the spring, cover the spring with a towel to prevent the spring from flying and possibly causing damage or personal injury.

    NOTE:

    Position a screw driver between the oil pump slide spring windings (2).

  3. Protect the engine front cover edge (1) with a suitable piece of plastic.
  4. Compress the oil pump slide spring with a screw driver and remove the oil pump slide spring along with the oil pump slide spring pin.
    5. Fig 3: Locating Engine Oil Pump Components
    GM2191039Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Mind the installation position of the oil pump components.

  5. Remove the oil pump components in the following order:
    1. Outer oil pump vane ring (1).
    2. Oil pump vane rotor (3) and the 7 oil pump vanes (2).
    3. Inner oil pump vane ring (6).
    4. Oil pump slide (4) and the 2 oil pump slide seals with the 2 oil pump slide seal springs (5).
scientia non olet · About LEMON Manuals