LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - Off Vehicle >> Cylinder Head Removal

Cylinder Head Removal

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cylinder Head Bolts Loosening Sequence
    GM2190736Courtesy of GENERAL MOTORS COMPANY
  1. Loosen the 12 cylinder head bolts in the sequence as shown. Use the following procedure:
    1. Loosen the cylinder head bolts 90 degrees.
    2. Loosen the cylinder head bolts 180 degrees.
    2. Fig 2: Cylinder Head, Gasket, Bolts And Guide Sleeves
    GM2190737Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not damage the guide sleeves (4) and (5).

  2. Remove and DISCARD the 12 cylinder head bolts (1).
  3. Remove the cylinder head (2).
  4. Remove the cylinder head gasket (3).
scientia non olet · About LEMON Manuals