LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Mechanical - 1.4L (LUV)) >> Repair Instructions - Off Vehicle >> Camshaft Position Actuator Solenoid Valve Installation

Camshaft Position Actuator Solenoid Valve Installation

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Position Actuator Solenoid Valves And Seal Rings
    GM2190650Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.

  1. Install the 2 camshaft position actuator solenoid valves (2) and the 2 seal rings (1) by carefully and evenly pressing.
    2. Fig 2: Camshaft Position Actuator Solenoid Valve Bolts
    GM2191735Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution

  2. Install the 4 camshaft position actuator solenoid valve bolts (1) and tighten to 8 N.m (71 lb in).
    3. Fig 3: Camshaft Position Actuator Solenoid Valves Proper Position
    GM2190651Courtesy of GENERAL MOTORS COMPANY
  3. The 2 camshaft position actuator solenoid valves should be installed in the position as shown (1) and (2).
scientia non olet · About LEMON Manuals