Installation Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install the throttle fasteners (3) along with a NEW throttle body seal ring (1).
- Install the 4 throttle body fastener (3) and tighten to 8 N.m (71 lb in).
- Install the charge air cooler outlet air hose to the throttle body. Refer to Charge Air Cooler Outlet Air Hose Replacement .
- Connect the throttle body wiring harness connector.
- Perform the throttle/idle learn. Refer to Q38 Throttle Body: Throttle/Idle Learn .
CAUTION:
Refer to Fastener Caution .