LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine Controls And Fuel - 1.4L (LUV) - Repair Instructions) >> Repair Instructions >> Ignition Coil Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the engine cover. Refer to Refer to Engine Cover Replacement .
    3. Fig 1: Ignition Coil Wiring Harness Connector And Fasteners
    GM2508825Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the ignition coil wiring harness connector (1).
  4. Remove the 2 ignition coil fasteners (2) from the ignition coil assembly (3).
    5. Fig 2: Ignition Coil Remover/Installer
    GM2579391Courtesy of GENERAL MOTORS COMPANY
  5. Install the EN-6009 remover/installer (1).
  6. Remove the ignition coil (2).
  7. Remove the EN-6009 remover/installer (1).
scientia non olet · About LEMON Manuals