LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine Controls And Fuel - 1.4L (LUV) - Repair Instructions) >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Position Actuator Solenoid Valves
    GM2191796Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.

    NOTE:

    Lubricate the seal rings with oil in order to make the installation easier.

  1. Carefully install the 2 camshaft position actuator solenoid valves (2) and the 2 seal rings (1) by gently pressing into position.
    2. Fig 2: Camshaft Position Actuator Solenoid Valve Bolts
    GM2191794Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the 4 camshaft position actuator solenoid valve bolts (1) and tighten to 8 N.m (71 lb in).
    3. Fig 3: Camshaft Position Actuator Solenoid Valves Proper Position
    GM2191797Courtesy of GENERAL MOTORS COMPANY
  3. The 2 camshaft position actuator solenoid valves should be installed in the position as shown (1) and (2).
    4. Fig 4: ECM Wiring Harness
    GM2191792Courtesy of GENERAL MOTORS COMPANY
  4. Clip ECM wiring harness (1) to camshaft cover.
  5. Connect the exhaust camshaft position actuator solenoid valve wiring harness plug (2).
  6. Connect the intake camshaft position actuator solenoid valve wiring harness plug (3).
scientia non olet · About LEMON Manuals