Circuit/System Description
Daytime Running Lamps - with TR6
The ambient light sensor is used to monitor outside lighting conditions. The body control module (BCM) provides a low reference ground and 5-volt reference signal to the ambient light sensor. Depending on outside lighting conditions, the ambient light sensor provides a voltage signal to the BCM that will vary between 0.2 and 4.9 volts. The BCM monitors the ambient light sensor signal circuit to determine if outside lighting conditions are correct for either daytime running lights (DRL) or automatic headlamp system control when the headlamp switch is in the AUTO position. In daylight conditions, the BCM will command the low beam headlamps (DRLs) ON by applying low voltage to the low beam headlamp control circuits illuminating the low beam headlamps at reduced intensity. Any function or condition that turns on the headlamps will cancel DRL operation.
Daytime Running Lamps - with T4A
The ambient light sensor is used to monitor outside lighting conditions. The body control module (BCM) provides a low reference ground and 5-volt reference signal to the ambient light sensor. Depending on outside lighting conditions, the ambient light sensor provides a voltage signal to the BCM that will vary between 0.2 and 4.9 volts. The BCM monitors the ambient light sensor signal circuit to determine if outside lighting conditions are correct for either daytime running lights (DRL) or automatic headlamp system control when the headlamp switch is in the AUTO position. In daylight conditions, the BCM responds by applying battery voltage to the left and right daytime running lamp relay control circuits which energizes both daytime running lamp relays. With the daytime running lamp relays energized, the switch contacts close allowing battery voltage to flow to the daytime running lamp control circuits illuminating the left and right daytime running lamp.