Circuit/System Testing

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Ignition OFF, disconnect the X5 harness connector at the K9 Body Control Module, ignition ON.
Verify a test lamp illuminates between the appropriate control circuit terminal listed below and ground.
- Terminal 13 (Encore/Trax/Holden)
- Terminal 10 (Opel)
- If the test lamp does not illuminate
1. Ignition OFF, disconnect the X2 harness connector at the X50A Fuse Block - Underhood.
2. Test for infinite resistance between the control circuit terminal and ground.
  - If less than infinite resistance, repair the short to ground on the circuit.
  - If infinite resistance
3. Test for less than 2 Ω in the control circuit end to end.
  - If 2 Ω or greater, repair the open/high resistance in the circuit.
  - If less than 2 Ω, replace the X50A Fuse Block - Underhood.
- If the test lamp illuminates
Ignition OFF, connect a 3 A fused jumper between the appropriate control circuit terminal listed below and ground.
- Terminal 13 (Encore/Trax/Holden)
- Terminal 10 (Opel)
Remove the front fog lamp fuse at the X50A Fuse Block - Underhood, ignition ON.
Verify a test lamp illuminates between the front fog lamp fuse B+ switch control terminal and ground.
- If the test lamp does not illuminate
1. Ignition OFF, disconnect the X2 harness connector at the X50A Fuse Block - Underhood, ignition ON.
2. Test for less than 1 V between the appropriate control circuit terminal listed below and ground.
  - Terminal 13 (Encore/Trax/Holden)
  - Terminal 10 (Opel)
  - If 1 V or greater, repair the short to voltage on the circuit.
  - If less than 1 V, replace the X50A Fuse Block - Underhood.
- If the test lamp illuminates
Test or replace the K9 Body Control Module.