LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Lighting System) >> Diagnostic Information and Procedures >> Courtesy Lamps Malfunction >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, all doors closed, all accessories OFF, disconnect the harness connector at the appropriate component listed below.
    • E37A Dome/Reading Lamps
    • E36AH Dome Lamp
    • A3L Sunshade - Left
    • A3R Sunshade - Right
  2. Test for less than 15 Ω between the appropriate ground circuit terminal listed below and ground.
    • E37A Dome/Reading Lamps - terminal 6
    • E36AH Dome Lamp - terminal 2
    • A3L Sunshade - Left terminal B
    • A3R Sunshade - Right terminal B
    • If 15 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 15 Ω 
  3. Connect a test lamp between the appropriate control circuit terminal listed below and ground.
    • E37A Dome/Reading Lamps - terminal 1
    • E36AH Dome Lamp - terminal 4
    • A3L Sunshade - Left terminal A
    • A3R Sunshade - Right terminal A
  4. Verify the test lamp turns ON and OFF when commanding the Inadvertent Load ON and OFF with a scan tool.
    • If the test lamp is always OFF 
    1. Ignition OFF, disconnect the X7 harness connector at the K9 Body Control Module.
    2. Test for infinite resistance between the control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If the test lamp is always ON 
    1. Ignition OFF, disconnect the X7 harness connector at the K9 Body Control Module, ignition ON.
    2. Test for less than 1 V between the control circuit terminal and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K9 Body Control Module.
    • If the test lamp turns ON and OFF 
  5. Test or replace the inoperative courtesy lamp.
scientia non olet · About LEMON Manuals