LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Power Steering System) >> Repair Instructions >> Power Steering Gear Outlet Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering gear outlet hose on the vehicle.
    2. Fig 1: Power Steering Gear Inlet And Outlet Hoses
    GM2808015Courtesy of GENERAL MOTORS COMPANY
  2. Install the power steering gear inlet and outlet hose seals (4) on the power steering gear inlet and outlet hoses.

    Use NEW seals.

  3. Power Steering Gear Outlet Hose to Steering Gear - Install
  4. Power Steering Gear Inlet Hose to Steering Gear - Install
    5. CAUTION:

    Refer to Fastener Caution .

  5. Power Steering Gear Inlet and Outlet Hose Bolt to Steering Gear - Install and tighten 11 N.m (97 lb in)
    6. Fig 2: Power Steering Gear Outlet Hose Bracket
    GM2809970Courtesy of GENERAL MOTORS COMPANY
  6. Secure the power steering gear outlet hose (3) to the vehicle frame using the power steering gear inlet hose bracket bolt (1) and the plastic push pin (2).
  7. Tighten the power steering gear outlet hose bracket bolt (3) to 9 N.m (80 lb in).
    8. Fig 3: Steering Gear Outlet Hose Clamp
    GM2809971Courtesy of GENERAL MOTORS COMPANY
  8. Power Steering Gear Outlet Hose to Power Steering Fluid Cooler - Install
  9. Power Steering Gear Outlet Hose Clamp to Power Steering Fluid Cooler - Install
  10. Install the right front tire and wheel assembly. Tire and Wheel Removal and Installation
  11. Fill and bleed the power steering system. Power Steering System Bleeding 
scientia non olet · About LEMON Manuals