LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove as much power steering fluid from the power steering fluid reservoir as possible.
    2. Fig 1: Power Steering Gear Inlet Hose And Seal
    GM2808012Courtesy of GENERAL MOTORS COMPANY
  2. Power Steering Gear Inlet Hose to Power Steering Pump - Remove
  3. Power Steering Gear Inlet Hose Seal to Power Steering Gear Inlet Hose - Remove

    DISCARD the seal.

    4. Fig 2: Steering Gear Inlet Hose
    GM2808013Courtesy of GENERAL MOTORS COMPANY
  4. Remove the power steering gear inlet hose bracket bolt (1) and separate the power steering gear inlet hose (2) from the vehicle engine.
  5. Raise and support the vehicle. Lifting and Jacking the Vehicle
    6. Fig 3: Power Steering Gear Inlet Hose And Bracket
    GM2808014Courtesy of GENERAL MOTORS COMPANY
  6. Remove the power steering gear inlet hose bracket bolt (1) and the plastic push pin (2) and separate the power steering gear inlet hose (3) from the vehicle frame.
    7. Fig 4: Power Steering Gear Inlet And Outlet Hoses
    GM2808015Courtesy of GENERAL MOTORS COMPANY
  7. Power Steering Gear Inlet and Outlet Hose Bolt to Steering Gear - Remove
  8. Power Steering Gear Inlet Hose to Steering Gear - Separate
  9. Power Steering Gear Outlet Hose to Steering Gear - Separate
  10. Remove the power steering gear inlet and outlet hose seals (4) from the power steering gear inlet and outlet hoses.

    DISCARD the seals.

  11. Remove the power steering gear inlet hose from the vehicle.
scientia non olet · About LEMON Manuals