LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Reservoir Inlet Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove as much power steering fluid from the power steering fluid reservoir as possible.
    2. Fig 1: Steering Fluid Reservoir Inlet Pipe
    GM2808003Courtesy of GENERAL MOTORS COMPANY
  2. Power Steering Fluid Reservoir Inlet Pipe Clamp to Power Steering Fluid Reservoir - Loosen
  3. Power Steering Fluid Reservoir Inlet Pipe to Power Steering Fluid Reservoir - Separate
    4. Fig 2: Power Steering Fluid Reservoir Inlet Hose
    GM2810051Courtesy of GENERAL MOTORS COMPANY
  4. Release the power steering fluid reservoir inlet hose (1) from the plastic clip (2) and remove the plastic push pin retainer (3).
    5. Fig 3: P/S Fluid Reservoir Inlet Pipe
    GM2810052Courtesy of GENERAL MOTORS COMPANY
  5. Power Steering Fluid Reservoir Inlet Pipe Clamp to Power Steering Fluid Cooler - Loosen
  6. Power Steering Fluid Reservoir Inlet Pipe to Power Steering Fluid Cooler - Separate
  7. Remove the power steering fluid reservoir inlet pipe from the vehicle.
scientia non olet · About LEMON Manuals