LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Power Steering System) >> Diagnostic Information and Procedures >> DTC C0545: Steering Wheel Torque Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the scan tool Steering Input Torque parameter changes when turning the steering wheel.
    • If the parameter does not change 
    1. Program the K43 Power Steering Control Module.
    2. Verify the DTC does not set.
      • If the DTC sets, replace the Steering Column.
      • If the DTC does not set
    3. All OK.
    • If the parameter changes 
  3. All OK.
scientia non olet · About LEMON Manuals