LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Suspension System General Diagnosis) >> Diagnostic Information and Procedures >> Ball Joint Inspection >> Notes

Ball Joint Inspection: Notes

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION:

    Refer to Vehicle Lifting and Jacking Caution .

  1. Raise the front of the vehicle to allow the front suspension to hang free.
  2. Grasp the tire at the top and the bottom.
  3. Move the top of the tire in an in-and-out motion.
  4. Look for any horizontal movement of the knuckle relative to the control arm.
  5. Ball joints must be replaced under the following conditions:
    • The joint is loose.
    • The ball seal is cut.
    • The ball stud is disconnected from the knuckle.
    • The ball stud is loose at the knuckle.
    • The ball stud can be twisted in its socket with finger pressure.
scientia non olet · About LEMON Manuals