LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Antilock Brake System) >> Diagnostic Information and Procedures >> Hill Descent Control Indicator Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the S48E Multifunction Switch - Center Console.
  2. Test for infinite resistance between the signal terminal 5 and the ground terminal 9 with the switch in the open position.
    • If less than infinite resistance 

      Replace the S48E Multifunction Switch - Center Console.

    • If infinite resistance 
  3. Test for less than 2 Ω between the signal terminal 5 and the ground terminal 9 with the switch in the closed position.
    • If 2 Ω or greater 

      Replace the S48E Multifunction Switch - Center Console.

    • If less than 2 Ω 
  4. All OK.
scientia non olet · About LEMON Manuals