Circuit/System Verification
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Verify DTC B101D is not set current or history in the K36 Inflatable Restraint Sensing and Diagnostic Module.
- If DTC B101D is set current or history in the K36 Inflatable Restraint and Sensing Diagnostic Module
Replace the K36 Inflatable Restraint Sensing and Diagnostic Module.
- If DTC B101D is not set current or history in the K36 Inflatable Restraint and Sensing Diagnostic Module
- If DTC B101D is set current or history in the K36 Inflatable Restraint and Sensing Diagnostic Module
- Verify the K36 Inflatable Restraint Sensing and Diagnostic Module is installed correctly.
- If loose or incorrect installation
Correct the installation or replace the component.
- If correct installation
- If loose or incorrect installation
- Verify DTC C0186, C0196, or C0287 is not set in the K36 Inflatable Restraint Sensing and Diagnostic Module.
- If any of the DTCs are set
Perform the Vehicle Yaw Sensor Learn .
- If none of the DTCs are set
- If any of the DTCs are set
- Verify DTC C0186, C0196, or C0287 is not set in the K17 Electronic Brake Control Module.
- If any of the DTCs are set
- Replace the K36 Inflatable Restraint Sensing and Diagnostic Module.
- Verify the DTC does not set while operating the vehicle within the Conditions for Running the DTC.
- If the DTC sets, replace the K17 Electronic Brake Control Module.
- If the DTC does not set
- All OK.
- If none of the DTCs are set
- All OK.