LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Antilock Brake System) >> Diagnostic Information and Procedures >> DTC C0161: Antilock Brake System Brake Switch >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify the stop lamps turn ON and OFF while applying and releasing the brake pedal.
    • If the stop lamps turn ON and OFF 
  3. Verify the Brake Pedal Position Sensor or the brake pedal are not binding causing residual brake pressure to be detected, while the brake lights operate properly.
    • If a condition is found 

      Repair or replace the appropriate component.

    • If a condition is not found 
  4. All OK.
scientia non olet · About LEMON Manuals