LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Hydraulic Brake System) >> Repair Instructions >> Rear Brake Intermediate Pipe Replacement (Left) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the left rear intermediate pipe from the vehicle.
  2. Position, but do not secure, the left rear intermediate pipe to the retaining clips.
    3. Fig 1: Left Rear Intermediate Pipe Fitting
    GM2772260Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the left rear intermediate pipe fitting (1) to the rear brake hose fitting and tighten the fitting to 18 N.m (13 lb ft).
    4. Fig 2: Left Rear Rail Retaining Clips
    GM2777587Courtesy of GENERAL MOTORS COMPANY
  4. Secure the left rear intermediate pipe to the left rear rail retaining clips (1).
    5. Fig 3: Rear Intermediate Pipe And Left Rail Retaining Clips
    GM2777583Courtesy of GENERAL MOTORS COMPANY
  5. Secure the left rear intermediate pipe to the left rail retaining clips (1).
    6. Fig 4: Left Rear Intermediate Pipe And Cross Vehicle Retaining Clips
    GM2777579Courtesy of GENERAL MOTORS COMPANY
  6. Secure the left rear intermediate pipe to the cross vehicle retaining clips (1).
    7. Fig 5: Left Rear Intermediate Pipe
    GM2777518Courtesy of GENERAL MOTORS COMPANY
  7. Secure the left rear intermediate pipe to the retaining clips (1).
    8. Fig 6: Rear Floor Retaining Clips
    GM2777427Courtesy of GENERAL MOTORS COMPANY
  8. Secure the left rear intermediate pipe to the rear floor retaining clips (1).
  9. Install the fuel tank. Refer to Fuel Tank Replacement (AWD) .
    10. Fig 7: Underbody Cross Sill Shield
    GM2777420Courtesy of GENERAL MOTORS COMPANY
  10. Install the underbody cross sill shield (1) and the 2 nuts.
    11. Fig 8: Rear Intermediate Pipe
    GM2599510Courtesy of GENERAL MOTORS COMPANY
  11. Secure the left rear intermediate pipe to the front floor retaining clips (1).
    12. Fig 9: Rear Intermediate Pipe And Retaining Clip
    GM2599512Courtesy of GENERAL MOTORS COMPANY
  12. Secure the left rear intermediate pipe to the retaining clip (1).
    13. Fig 10: Front Brake Pipe Retaining Clips
    GM2599513Courtesy of GENERAL MOTORS COMPANY
  13. Secure the left rear intermediate pipe to the retaining clips (1).
    14. Fig 11: Left Rear Intermediate Pipe Fitting
    GM2599517Courtesy of GENERAL MOTORS COMPANY
  14. Connect the left rear intermediate pipe fitting (1) to the BPMV and tighten the fitting to 18 N.m (13 lb ft).
  15. Install the battery. Refer to Battery Replacement .
  16. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) .
scientia non olet · About LEMON Manuals