LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Hydraulic Brake System) >> Repair Instructions >> Rear Brake Hose Replacement (Disc Brake) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Brake Dust Warning .

WARNING:

Refer to Brake Fluid Irritant Warning .

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: Left Rear Intermediate Pipe Fitting
    GM2772260Courtesy of GENERAL MOTORS COMPANY
  3. Remove the brake pipe fitting (1) from the rear brake hose.
  4. Cap the brake pipe fitting to prevent brake fluid loss and contamination.
    5. Fig 2: Brake Hose Retainer
    GM2772261Courtesy of GENERAL MOTORS COMPANY
  5. Remove the brake hose retainer (1).
    6. Fig 3: Brake Hose Fitting Bolt
    GM2771546Courtesy of GENERAL MOTORS COMPANY
  6. Remove the brake hose fitting bolt (1).
    7. NOTE:

    Do not reuse the brake hose fitting gaskets.

  7. Remove and discard the brake hose fitting gaskets (2) from the brake hose fitting (3).
  8. Remove the brake hose.
scientia non olet · About LEMON Manuals