Removal Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- With the engine OFF, apply and release the brake pedal several times to deplete the power vacuum brake booster vacuum reserve.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Through the left front wheelhouse, disconnect the power brake booster vacuum hose quick connect (1) from the power brake booster pump port.
- Lower the vehicle.
- Disconnect the power brake booster vacuum hose quick connect (1) from the intake manifold vacuum port.
- Disconnect the power brake booster vacuum sensor electrical connector.
- Remove the power brake booster vacuum sensor and hose assembly (1) from the power vacuum brake booster grommet.
- Release the clamp and remove the power brake booster vacuum sensor (1).
- Remove the power brake booster vacuum hose assembly.