Removal Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- With the engine OFF, apply and release the brake pedal several times until the brake pedal becomes firm to deplete the power brake booster vacuum reserve.
- Remove the battery tray. Refer to Battery Tray Replacement .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Through the left front wheehouse, disconnect the power brake booster vacuum hose quick connect (1) from the power brake booster pump port.
- Lower the vehicle.
- Disconnect the power brake booster pump electrical connector.
- Release the power brake booster pump vent hose and grommet (1) from the left side rail.
- Remove the power brake booster pump bracket nuts (1).
- Remove the power brake booster pump assembly.
- If replacing the power brake booster pump, remove the power brake booster pump bracket. Refer to Power Brake Booster Pump Bracket Replacement .