Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Proportion Valve

Courtesy of GENERAL MOTORS COMPANY

Install the proportion valve (1).

Fig 2: Proportion Valve Nut

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the proportion valve nut (1) and tighten to 15 (11 lb ft).

Fig 3: Master Cylinder Left Rear Brake Pipe Fitting

Courtesy of GENERAL MOTORS COMPANY

Connect the left rear brake pipe fitting (1) and tighten to 18 (13 lb ft).

Fig 4: Master Cylinder Right Front Brake Pipe Fitting

Courtesy of GENERAL MOTORS COMPANY

Connect the right front brake pipe fitting (1) and tighten to 18 (13 lb ft).

Fig 5: Master Cylinder Left Rear Brake Pipe Fitting

Courtesy of GENERAL MOTORS COMPANY

Connect the left front brake pipe fitting (1) and tighten to 18 (13 lb ft).

Fig 6: Master Cylinder Right Rear Brake Pipe Fitting

Courtesy of GENERAL MOTORS COMPANY

Connect the right rear brake pipe fitting (1) and tighten to 18 (13 lb ft).

Fig 7: Master Cylinder Primary Brake Pipe Fitting

Courtesy of GENERAL MOTORS COMPANY

Connect the master cylinder primary brake pipe fitting (1) to the brake proportion valve and tighten to 18 (13 lb ft).

Fig 8: Master Cylinder Secondary Brake Pipe Fitting

Courtesy of GENERAL MOTORS COMPANY

Connect the master cylinder secondary brake pipe fitting (1) to the brake proportion valve and tighten to 18 (13 lb ft).
Install the battery. Refer to Battery Replacement .
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) Hydraulic Brake System Bleeding (Pressure) .